Restore Factory Default Settings - NetComm HSPA+ M2M User Manual

Restore Factory Default Settings

Restoring factory defaults will reset the NTC-40 to its factory default configuration. Occasions may present themselves where you
need to restore the factory defaults on your NTC-40 such as:
You have lost your username and password and are unable to login to the web configuration page;

You have purchased your NTC-40 from someone else and need to reconfigure the device to work with your 3G

service;
You are asked to perform a factory reset by support staff.

In order to restore your NTC-40 to its factory default settings, please follow these steps:
Ensure that your NTC-40 Router is powered on (for at least 10 seconds);

Use a paper clip or a pencil tip to depress the reset button for ten seconds until the LEDs on the front of the router

start to flash in an ON / OFF sequence and then release.
 At this point, refresh your browser and check that the banner now reads "NetComm NTC-40 Cellular Router Recovery
Console".
 Select the Settings option from the menu before selecting the "Restore" button.
 When the Power light returns to a steady red, the reset is complete. The default settings are now restored. The entire
process takes about 45 seconds to complete.
Once you have reset your NTC-40 Router to its default settings you will be able to access the device's configuration web interface
using http://192.168.1.1 with username 'admin' or 'root' and password 'admin'.
YML40V
www.netcomm-commercial.com.au
NTC-40 Series – HSPA+ M2M WiFi Router
NTC-40 –HSPA+ M2M WiFi Router with Voice
11