NetComm HSPA+ M2M User Manual page 21

Band / Provider
The band settings page enables you to select which frequency band you will use for your connection and enable you to scan for
available network operators in your area.
You may want to do this if you're using the router in a country with multi frequency networks that may not all support HSPA. You
can select the router to only connect on the network frequencies that suit your requirements.
Make your selection from the "Change Band:" drop down list.
The default setting of "All bands" should be appropriate for the majority of users.
You can also scan for available 3G service providers in your area by selecting "Manual" for the "Current Operator Selection Mode"
and then clicking the scan button.
A list of the detected 3G service carriers in your area will be displayed. Select the most appropriate 3G service from the list shown
and click "Apply".
The default setting of "Automatic" should be appropriate for the majority of users and locations.
YML40V
www.netcomm-commercial.com.au
Figure 14 - Band / Provider Selection
Figure 15 - Manual Operator Selection
NTC-40 Series – HSPA+ M2M WiFi Router
NTC-40 –HSPA+ M2M WiFi Router with Voice
21