NetComm HSPA+ M2M User Manual page 62

Remote firmware upgrade
The remote firmware update process has one step:
1. Upload and install the main system image to the router.
Please note: Do not interrupt the power during a remote firmware upgrade, as this may render the router unable to start up
and will require a local system recovery upload to be performed.
Upload and install the system recovery image onto the router. You can do this by clicking on the browse button and then to
navigate to where the recovery image upgrade file is located on your computer.
Once you have selected the recovery image file to use, click Upload to upload the file. You will then see a progress bar as shown in
the screenshot below. The upload has finished when the status bar reaches 100%.
When the upload has completed, the screen should refresh and list the file you have just uploaded. Click on the "Install" link to the
right of this.
Once you see "Done" shown as per the screenshot below, the router will have automatically reboot, and installed the new main
system image. It should also reconnect to your selected Internet service.
Please note: This process can take up to 10 minutes.
NTC-40 –HSPA+ M2M WiFi Router with Voice
62
Figure 60 - Remote Firmware Upgrade - Upload Firmware
Figure 61 - Remote Firmware Upgrade - Firmware Update
NTC-40 Series – HSPA+ M2M WiFi Router
www.netcommwireless .com
YML40V