Table of Contents
Advertisement
Restoring Factory Default Settings
Restoring the NTC-30WV factory default settings will erase any configuration changes you have made. You may encounter
situations where you need to restore the factory defaults on your router, such as:
You have lost your username and password and are unable to login to the web configuration page.
You are asked to perform a factory reset by support staff.
There are two methods you can use to restore factory default settings on your NTC-30WV:
Using the web-based user interface
Using the reset button on the interface panel of the router
Using the web-based user interface
In order to restore your router to its factory default settings, please follow these steps:
1.
Ensure that your NTC-30WV router is powered on (for at least 10 seconds);
2.
Use a paper clip or a pencil tip to depress the reset button for ten seconds and release. At this point, the reset is in
progress. Do not power off the unit.
3.
Logon to the default web interface page at
password. You will be re-directed into the gateway recovery mode. Select the System menu option and then click
Load/Save. Press the Restore button to complete the factory reset.
4.
When the Power light returns to a steady red, the reset is complete. The default settings are now restored. The entire
process takes about 45 seconds to complete.
Using the reset button on the interface panel of the router
Hold the reset button down until all LEDs on the front panel of the router stop flashing simultaneously and then release the
button. The router will restore the factory default settings and reboot.
Once you have reset your NTC-30WV to its default settings you will be able to access the device's configuration web interface using
http://192.168.1.1
with username admin and password admin.
www.netcommwireless.com
http://192.168.1.1
using root as the User Name and admin as the
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
13
Advertisement
Table of Contents
