Wireless Lan; Configuration - NetComm HSPA+ M2M User Manual

Wireless LAN

Configuration

The configuration page is used to define the basic wireless settings for the NTC-40 such as the SSID and Wireless Security in use.
OPTION
WiFi is turned on by default. Changing this option to OFF will turn OFF the wireless functionality on the NTC-40 and you will not be
Radio On/Off
able to connect wirelessly.
Country Select the country you are operating the NTC-40 in.
There are 6 possible network modes to use depending on the capability of your devices' wireless network cards. Each mode
represents one or more wireless network protocols. Each wireless device will be capable of receiving some but possibly not all of
wireless broadcast protocol types. They are:
Network Mode
Frequency (Channel) Select the wireless channel that the wireless signal will broadcast on.
SSID The SSID (Service Set IDentifier or Network Name) in use for the wireless network.
Network Authentication The wireless security settings. See below for in depth analysis.
WPA Pre-Shared Key The wireless security key or wireless password.
WPA Group Rekey Interval The time in seconds before a new key is generated.
WPA Encryption The type of WPA encryption. Options include AES, TKIP or TKIP + AES.
MAC Address The MAC address of the wireless network card.
WDS Mode The Status of the WDS (Wireless Distribution System) Mode
Click 'Apply' to save any changes to the settings.
YML40V
www.netcomm-commercial.com.au
Figure 34 - Wireless Configuration - Basic Settings

802.11b/g/n mixed mode.
 802.11b only.
 802.11g only.

802.11n only.
 802.11b/g/n mixed mode.
Table 22 - Wireless Configuration - Basic Configuration Items
NTC-40 Series – HSPA+ M2M WiFi Router
DEFINITION
NTC-40 –HSPA+ M2M WiFi Router with Voice
39