NetComm HSPA+ M2M User Manual page 20

To confirm successful connection
1. Click on the Status menu item at the top of the page to return to the Status page.
2. The WWAN (mobile broadband) status should be ''up".
3. The Local field should show the current IP address that the network has allocated for the router.
4. Congratulations. Your new router is now ready to use!
PPPoE
The PPPoE page is used to configure a transparent PPPoE connection. This can be used to provide a bridged connection.
To enable PPPoE mode, firstly ensure the "Auto Connect" is disabled in all the profiles on the "Connection" configuration page by
clicking on the "Internet Settings" menu followed by "Mobile Broadband" and then the "Connection" menu item on the right and
select each connection profile and disable the Auto Connection option and save the updated settings..
1. Select "Enable" to enable PPPoE.
2. Specify the APN supplied by your 3G provider.
3. Specify a "Service Name". (Optional)
This is particularly useful if you have more than one PPPoE router or modem on a single Ethernet network.
Click "Save" to save your settings and enable PPPoE.
NTC-40 –HSPA+ M2M WiFi Router with Voice
20
Figure 13 - PPPoE Settings
NTC-40 Series – HSPA+ M2M WiFi Router
www.netcommwireless .com
YML40V