Installation; Wire Color Table Of The Rf 10 / Rf 20 - IDTECK Star RF10 User Manual

Installation

6.
6-1. Mullion/Wall Mount
Drill two 3.5*40 or 3.5*25 screw holes in the designated location of the wall
vertically and drill one 12mm(0.47") hole for the controller cable in the center of the two holes.
6-2. Pass the reader cable through the center hole and install the reader module by using two 3.5*40
or 3.5*25 screws.
6-3. Put bezel on the reader module and push bezel
.

7. Wire Color Table of the RF 10 / RF 20

Main Power (+12V)
Power Ground (GND)
Not Connect
Wiegand Data 0 Out
Wiegand Data 1 Out
Buzzer Control In
LED Control In
* Please cut out tail connector before installation.
SIGNAL
RS232 (TX)
COLOR
Red
Black
Orange
Green
White
Blue
Yellow
Brown
7
User's Manual
83.8mm(3.3") apart