Wire Connection To Access Controller; Operation - IDTECK Star RF10 User Manual

8. Wire Connection to Controller
Access Controller
Main Power (+12V)
Power Ground (GND)
Wiegand Data 0 Out
Wiegand Data 1 Out
Buzzer Control In

9. Operation

9-1. If power is supplied to the RF10/20, red light is turned on and the reader goes into standby.
9-2. Present a RF card close to the product until you hear beep sound. The LED of RF10/20 turns into
green simultaneously and the reader sends card data to the controller. And then, LED turns into
red and the reader goes into standby again for next reading.
9-3. LED Control
You can change LED color setting oppositely by connecting LED Control Input wire (Yellow wire)
to Power GND. In this case, Green light is turned on when the reader is on standby and once you
present RF card, the LED of RF10/20 turns into red simultaneously. And then, it turns into green
again for next reading.
9-4. Buzzer Control
If Buzzer Control Input wire (Blue wire) is connected to Power GND, buzzer generates sound
continuously. Cards cannot be read during the buzzer is operating.
Not Connect
LED Control In
RS232 (TX)
RED
BLACK
ORANGE
GREEN
WHITE
BLUE
YELLOW
BROWN
8
User's Manual