Chapter 7 - Connector Pinouts; Audio Input / Output Connectors (Xlr-3); Power Connector (Hirose-4 Connector); Audio Input / Output Connectors (Ta-5) - Zaxcom Nomad User Manual

Zaxcom Nomad User's Manual_____________________________________________________Chapter 7
This section provides the pinouts for the connectors on the Nomad. The mating cable connector part number is
also provided for the less common connectors.
NOTE: All of the diagrams in this chapter show the solder side of each connector.

Audio Input / Output Connectors (XLR-3)

When building an analog cable, use balanced XLR cable.

Power Connector (Hirose-4 Connector)

Audio Input / Output Connectors (TA-5)

Mono & Tape Output Connectors (1/8" TRS)
NOTE: Since the ring connector is not being used, you can use a TS plug.
Chapter 7 – Connector Pinouts
3
1
Figure 7-1 XLR-3M (Left) and XLR-3F (Right) Pin Numbering
Pin Description
Ground
1
(X – shield)
Table 7-1 XLR-3 Pin Description
Pin DESC
–
1 ( ) / Cold
3 N/C
Table 7-2 Hirose-4 Pin Description
Pin DESC
1 Ground
3 Channel A -
5 Channel B -
Table 7-3 TA-5F & TA-5M Pin Description
Pin Description
Tip +
Table 7-4 Mono & Tape Output Pin Description
69
3
2 2
Pin Description Pin
(+) / Hot
2 3
(L – live)
Pin DESC
2 N/C
4 (+) / Hot
Pin DESC
2 Channel A +
4 Channel B +
Pin Description Pin
Ring N/C Sleeve
1
Description
–
( ) / Cold
(R – return)
Description
Ground