Display And Menu Button - Inter-Tel 8664 User Manual

Display and Menu Button

In addition to the various feature buttons, your endpoint contains a display that shows
information about status, modes, call information, and available features. When the
endpoint is in the active mode, pressing
the display. To access an option, press the number on your dialpad that corresponds to
the number on the display. While the four-line menu display is showing, all button
presses relate to the menu options only. To make a call, you must return to the two-
line display.
The
MENU
example, the illustration below on the left shows what the two-line display looks like
when you are on an active IC call to Jane Jones. When you press
changes from the two-line informational display to the four-line menu option display.
To put your call to Jane on HOLD press
Because the display can only support 15 characters, you may see a few abbreviations.
The most commonly used abbreviations are provided in the table below.
NOTE:
The backlight comes on when any button is pressed or when there is an incom-
ing call. This light turns off after 10 seconds if another button is not pressed within that
period.
8
button allows you to toggle between the two- and four-line displays. For
Two-Line Display
5
IC TO JANE JONES
ABBREVIATION
ACCT CODE Account Code
CNF Conference
DEST Destination
DIR Directory
DND Do-Not-Disturb
EXT Extension
MSG Message
RCL Recall
STN SPD Station Speed Dial
SYS SPD System Speed Dial
TFR Transfer
TG Trunk Group (a group of outside lines)
TRNK Trunk (an outside line)
,
,
or will bring up options on
MENU FCN LINE
on your dialpad.
1
Four-Line Display
5
1 HOLD
3 TRANSFER
5
TRANSFER-T-HLD
7 MUTE
WORD/PHRASE
®
Inter-Tel Model 8664/8665 User Guide
, the display
MENU
2
CNF 4
>> 8