Setting Up The Dvr To Record Motion - Watchguard DVR4ENTPACK3 User Manual

Setting up the DVR to record Motion

How to setup the DVR to do Motion Recording

Press "MENU" and scroll down until you reach "ADVANCED CONFIG  RECORD" and press "ENTER"

Set "MANUAL RECORD ENABLE" to "OFF"

Set "EVENT RECORD ENABLE" to "ON"

Press "MENU" to return to the main menu. Scroll down to "ADVANCED CONFIG  DETECTION" and press
"ENTER"

Set each camera's detection (DET) to "ON". You can also setup the area of detection and sensitivity for each
camera. (Refer to page 9 of this manual for further information about these functions)

The DVR is now set to record motion.
If you wish to turn off the Alert Buzzer, follow these steps:

Press "MENU" to bring up the main menu. Scroll down to "ADVANCED CONFIG  ALERT" and press
"ENTER"

Set the motion buzzer to "OFF"
- 24 -