Expert Adjustment - Konica Minolta magicolor 8650 User Manual

Settings for control panel

Expert Adjustment

Menu
PrinterAdjustment
Finisher Adjust
DensityAdjustment
Stabilization
ColorRegistration
Test Pattern
Note
If "Print" is selected for [PrinterAdjustment], test print is performed through which you can check the
set value.
[Finisher Adjust] is displayed when the finisher is installed.
Settings for [Center Staples Pos] and [Half-Fold Pos] in [Finisher Adjust] vary depending on the finisher
installed. When FS-609 is installed, the values for position adjustment can only be specified. When
FS-519 is installed, the values for position adjustment can be specified for each paper size or paper
type.
magicolor 8650
Leading Edge Adj.
Centering
Leading (Duplex)
Centering (Duplex)
Vertical Adj.
EraseLeadingEdge
Center Staple Pos
Half-Fold Pos.
Thick/Yellow
Thick/Magenta
Thick/Cyan
Thick/Black
BlackImageDensity
Initialize+Stabi.
StabilizationOnly
Yellow
Magenta
Cyan
Gradation Pattern
Halftone Pattern
EDNord - Istedgade 37A - 900 Aalborg - telefon 9633 3500
Description
Adjust the starting print position between -3.0 and
3.0mm at the leading edge of the paper (with respect
to the paper feed direction). Adjustments can be spec-
ified for each paper type.
Adjust the starting print position between -3.0 and
3.0mm at the left edge of the paper (with respect to the
paper feed direction). Adjustments can be specified
for each paper tray.
Adjust the starting print position between -3.0 and
3.0mm at the leading edge of the paper for the second
side during automatic double-sided copying. Adjust-
ments can be specified for each paper tray.
Adjust the starting print position between -3.0 and
3.0mm at the left edge of the paper for the second side
during automatic double-sided copying. Adjustments
can be specified for each paper tray.
Specify a zoom in the paper feed direction within the
range from -7 and +7.
Specify the non-printing area of the leading edge of
the paper.
Adjust the stapling position (between -10 and 10mm)
when printing with the "Center Staple & Fold" setting.
Adjust the folding position (between -10 and 10mm)
when printing with the "Center Staple & Fold" setting.
Adjust the image density for printing on thick paper or
transparencies. The density can be adjusted separate-
ly for each color (yellow, magenta, cyan and black for
a color image and the black image density). The higher
the setting, the darker the density.
Adjust the setting for yellow, magenta, cyan and black
between -5 and +5.
Adjust the setting for "Black Image Density" between -
2 and +2.
Perform an image stabilization if the image is incorrect,
even after the gradation levels have been adjusted.
• Initialize+Stabi.: Perform a normal image stabiliza-
tion.
• StabilizationOnly: Select when a good result was
not achieved after "Initialize+Stabi". was selected.
Adjust the color registration if color shifts can be seen
in the print result.
Print the test pattern of each color gradation.
Print the test pattern of each halftone.
9
Default
Setting
0.0mm
0.0mm
0.0mm
0.0mm
0
4mm
00mm
00mm
0
0
0
0
0
Initial-
ize+Stabi.
0
0
0
–
–
9-29