Setting Up The Security Gateway For Configuration; Connecting To The Private Port - Avaya SG203 Hardware Installation Manual

Chapter 3 Setting up the security gateway for

Connecting to the private port

Issue 1, June 2003
configuration
This chapter describes how to set up the security gateway addressing
and remote connectivity capabilities. This preliminary configuration is
performed using a browser on your workstation connected to the security
gateway's private port. When the security gateway is initially installed and
connected to the local LAN, it is provisioned with a default IP address for
the DHCP server (serving the private port), allowing access to the device
through a Web browser on a workstation.
The following procedure assumes that the security gateway has been
physically installed on the network, according to the instructions provided
in Chapter 2, Installing SG203 and SG208 Security
The security gateway quick setup consists of two basic steps:
Establishing connectivity between a workstation or IP device on your
1.
local network with the security gateway's private port
Setting up the security gateway's public port to reach the Internet
2.
Through the Web interface, you can assign a static IP address for the
public port, a password, server addresses, DHCP settings, and a default
gateway. Once this has been done, the security gateway can be
completely configured and incorporated into your Virtual private Network
either by using the Web interface locally, or using Avaya VPNmanager
from a central location.
From the workstation's control panel, select your TCP/IP network
component for your Ethernet controller. In the IP Address window select
"enable the setting" to "Obtain an IP address automatically" .

Setting up the security gateway for configuration 23

Gateway.