Table of Contents
Advertisement
General Information
•
Local Bus interface:
-
Three parts of 133MHz SDRAM memory (optional), 64Mbyte size with parity.
-
One 8Mbyte (expandable) Flash with 16bit port size in socket.
-
Address Latch and Buffers to support slow devices on the PIB Board.
-
Mictor Logic Analyzer Connector on mux bus for evaluation only.
•
Two Hi-speed Riser Connectors to enable connection to the PIB Board.
•
Debug port access via dedicated 16-pin connector (COP), via PCI port or from parallel port
interface on the PIB.
•
One I2C port for EEPROM 256Kbyte, Real Time Clock (RTC) and SODIMM SPD
EEPROM parts - the second I2C port connects to the Board Revision Detect 1Kbyte
EEPROM.
•
Can function in one of three configurations:
-
Stand-alone.
-
As a PCI add-in card for a standard PC computer (Agent Mode).
-
PIB combined mode - development platform with Processor Board and PIB connected
together.
•
Board Control and Status Register (BCSR) implemented in Xilinx FPGA.
•
Three power options:
-
Main 5V power is fed from external power supply for stand-alone mode.
-
Power from PC supply when acting as a PCI add-in card.
-
Power from the PIB when PIB and Processor Boards are combined.
•
PCI add-in card form factor dimensions: 285mm x 106mm.
1.6
External Connections
The MPC8349E MDS Processor Board interconnects with external devices via the following set
of connectors:
•
P1 - MiniAB USB connector.
•
P2 - RJ45-10 for DUART signals.
•
P3, P6, P7, P8 - four Logic Analyzer MICTOR Connectors.
•
P4 - 64-bit PCI Edge Connector.
•
P5 - SMB RF Connector for external pulse generator - not assembled.
•
P9 - 16-pin COP/JTAG Connector.
•
P10 - 16-pin header for FPGA In-System Programming.
•
P11 - Voltage Input
•
P12,P13 - 300-pin FCI Expansion Connectors.
•
J1,J2 - RJ45 8pin Gigabit Ethernet Connectors.
12
MPC8349E MDS Processor Board User's Manual
Freescale Semiconductor
Advertisement
Table of Contents
