4.3.27 Resist Roller, Hopping Roller, Sensor Plates
(1) Disassembly procedure
1) Resist Roller, Hopping Roller
1.
First, carry out the disassembly
procedure up to the point of the Lower
Base removal.
2.
Remove the One-way Clutch Gear.
3.
Press the Resist Roller to the right side
and lift up the left side of it, then take off
the Resist Roller.
4.
Remove the One-way Clutch Gear and
Bearing.
5.
Remove the Hopping Roller by sliding to
the right side.
2) Sensor Plates (Inlet, Outlet), Toner Sensor
1.
After removing the Lower Base, remove
the Sensor Plate by pressing and holding
the latches while shifting the Sensor
Plate up and out.
Service Guide OKIFAX 5750/5950
Chapter 4 Disassembly
Page: 193