Outline Of Parallel Pickup - Oki OKIFAX 5750 Service Manual

2.9.2.6 Outline of Parallel Pickup

Parallel pick up is a function that controls a fax (to make a fax in receive mode) from a telephone set connected parallel to a fax. The two possible parallel
connections of telephone sets A and B are shown in the figure.
Remote control: To control a fax from telephone set A
Parallel Pick Up (PP): To control a fax from telephone set B.
l
Why a PP function is needed !
As shown in the block diagram on the next page, telephone sets B, A, A' and A" are connected to a telephone line.
Since A, A' and A" are connected to the line via fax, off-hook status of any of the telephone sets can be detected by the OFF-HOOK Detector 16 in the block
diagram.
However, off-hook status of telephone set B cannot be detected by the fax side.
l
PP Control
When a normal ring arrives at the fax from the line, the CML 7 turns on resulting in the formation of an AC loop via circuit 13. The AC loop makes it possible for
the modem to detect the AC signals. If a user hooks up telephone set B after the first ring and enters the MF 2-digit special code in order to make the fax in the
receive mode, then it becomes possible to detect the MF signals along the remote.
< front view >
Service Guide OKIFAX 5750/5950
Chapter 2 Installation
Page: 113