Ip-Mac Binding Table - D-Link xStack DES-3800 Series User Manual

IP-MAC Binding Table

The window shown below can be used to create IP-MAC binding entries. Click Security > IP-MAC Binding > IP-MAC
Binding Table to view the IP-MAC Binding Setting window. Enter the IP and MAC addresses of the authorized users in the
appropriate field, choose the designated ports, and click Add. To modify either the IP address or the MAC address of the binding
entry, make the desired changes in the appropriate field and Click Modify. To find an IP-MAC binding entry, enter the IP and
MAC addresses and click Find. To delete an entry click Delete. To clear all the entries from the table click Delete All.
Parameter
IP Address
MAC Address
All Ports
Ports
Mode
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Figure 11- 51. IP-MAC Binding Table window
Description
Enter the IP address to bind to the MAC address set below.
Enter the MAC address to bind to the IP Address set above.
Click this check box to configure this IP-MAC binding entry (IP Address + MAC Address) for all
ports on the Switch.
Specify the switch ports for which to configure this IP-MAC binding entry (IP Address + MAC
Address). Click the All check box to configure this entry for all ports on the Switch.
The user may set the IP-MAC Binding Mode here by using the pull-down menu. The choices
are:
ARP – Choosing this selection will set a normal IP-Mac Binding entry for the IP address and
MAC address entered. If the system is in ARP mode, the arp mode entries and acl mode
entries will be effective. If the system is in the acl mode, only the acl mode entries will be
active.
ACL – Choosing this entry will allow only packets from the source IP-MAC binding entry
created here. All other packets with a different IP address will be discarded by the Switch. This
mode can only be used if the ACL Mode has been enabled in the IP-MAC Binding Ports
window as seen previously.
276