Save Changes; Logout - D-Link xStack DES-3800 Series User Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch

Save Changes

The Switch has two levels of memory; normal RAM and non-volatile or NV-RAM. Configuration changes are made effective by
clicking the Apply button. When this is done, the settings will be immediately applied to the switching software in RAM, and will
immediately take effect.
Some settings, though, require you to restart the Switch before they will take effect. Restarting the Switch erases all settings in
RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save all setting changes to NV-RAM before
rebooting the Switch.
To retain any configuration changes permanently, click the Save Changes link. The following window will appear:
Figure 13- 3. Save Configuration window
The Switch contains two places to save configuration settings in its internal memory. Using the pull down menu, the user may
select a place to put the save configurations, marked as 1 or 2. Also, the user may select the current settings to be the current
active configurations of the Switch by selecting Active. These settings will be used every time the Switch is rebooted. Clicking the
Save button will save the configurations to the place set above. The following dialog box will confirm that the configuration has
been saved:
Figure 13- 4. Save Settings dialog box

Logout

Use the Logout page to logout of the Switch's Web-based management agent by clicking on the Log Out button.
Figure 13- 5. Logout Web Setup window
328