Web-Based Switch Configuration; Introduction; Login To Web Manager - D-Link xStack DES-3800 Series User Manual

Web-based Switch Configuration

Introduction

Login to Web manager

Web-Based User Interface
Basic Setup
Reboot
Basic Switch Setup
Network Management
Switch Utilities
Network Monitoring
IGMP Snooping Status
Introduction
All software functions of the Switch can be managed, configured and monitored via the embedded web-based (HTML) interface.
The Switch can be managed from remote stations anywhere on the network through a standard browser such as Opera, Netscape
Navigator/Communicator, or Microsoft Internet Explorer. The browser acts as a universal access tool and can communicate
directly with the Switch using the HTTP protocol.
The Web-based management module and the Console program (and Telnet) are different ways to access the same internal
switching software and configure it. Thus, all settings encountered in web-based management are the same as those found in the
console program.
Login to Web Manager
To begin managing the Switch, simply run the browser installed on your computer and point it to the IP address defined for the
device. The URL in the address bar should read something like: http://123.123.123.123, where the numbers 123 represent the IP
address of the Switch.
This opens the management module's user authentication window, as seen below.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
NOTE: The Factory default IP address for the Switch is 10.90.90.90.
Figure 5- 1. Enter Network Password window
Section 5
26