Dhcp Server Manual Binding Settings - D-Link xStack DES-3800 Series User Manual

addresses.
Net BIOS Name Enter the IP address of a Net BIOS Name Server that will be available to a Microsoft DHCP
Server Client. This Net BIOS Name Server is actually a WINS (Windows Internet Naming Service)
Server that allows Microsoft DHCP clients to correlate host names to IP addresses within a
general grouping of networks. The user may establish up to 3 Net BIOS Name Servers.
NetBIOS Node This field will allow users to set the type of node server for the previously configured Net BIOS
Type Name server. Using the pull-down menu, the user has for node type choices which are
Broadcast, Peer to Peer, Mixed and Hybrid.
Default Router Enter the IP address of the default router for a DHCP Client. Users must configure at least one
address here, yet up to three IP addresses can be configured for this field. The IP address of the
default router must be on the same subnet as the DHCP client.
Pool Lease Using this field, the user can specify the lease time for the DHCP client. This time represents the
amount of time that the allotted address is valid on the local network. Users may set the time by
entering the days into the open field and then use the pull-down menus to precisely set the time
by hours and minutes. Users may also use the Infinite check box to set the allotted IP address
to never be timed out of its lease. The default setting is 1 day.
Boot File This field is used to specify the Boot File that will be used as the boot image of the DHCP client.
This image is usually the operating system that the client uses to load its IP parameters.
Next Server This field is used to identify the IP address of the device that has the previously stated boot file.
Click Apply to implement changes made.

DHCP Server Manual Binding Settings

The following windows will allow users to view and set manual DHCP entries. Manual DHCP entries will bind an IP address with
the MAC address of a device within a DHCP pool. These entries are necessary for special devices on the local network which will
always require a static IP address that cannot be changed. To view this window, click L3 features > DHCP Server > DHCP
Server Manual Binding Settings.
Figure 8- 47. DHCP Server Manual Binding Settings and DHCP Server Manual Binding Table
Users may set a manual DHCP Binding entry by entering the information and clicking Add. To clear an entry click the Clear All
button.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
162