Connecting The Switch; Switch To End Node - D-Link xStack DES-3800 Series User Manual

Connecting the Switch

Switch to End Node

Switch to Hub or Switch
Connecting to Network Backbone or Server
Switch to End Node
End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ 45 Ethernet/Fast Ethernet Network Interface Card (NIC) and
most routers. An end node can be connected to the Switch via a twisted-pair Category 3, 4, or 5 UTP/STP cable. The end node
should be connected to any of the ports of the Switch.
The Link/Act LEDs for each UTP port will light green or amber when the link is valid. A blinking LED indicates packet activity
on that port.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
NOTE: All 24 high-performance NWay Ethernet ports can support both
MDI-II and MDI-X connections.
Figure 3- 1. Switch connected to an end node
Section 3
16