Table of Contents
Advertisement
U n p a c k i n g
Upon receipt of the projector at the final destination, unpack as follows:
1.
Examine shipping crate or carton for visible shipping damage prior to removing the projector. Note any damage.
2.
Carefully remove the shipping crate or carton from the unit.
3.
Inspect the projector for shipping damage. Notify the carrier if such damage exists.
4.
Remove rear panels of cabinet, and remove all packing material and restraints. Remove any package accessories,
connectors, cables, power supply, keypad, etc. Check all items against packing list.
I n s t a l l a t i o n
1.
Prepare the floor area required for projector installation. The selected floor area should be of extremely solid
construction to minimize transmission of floor vibration to projection equipment.
2.
When the projector is supplied without a lamphouse, attach the projector with the four bolts supplied to the
lamphouse base. Refer to the lamphouse manual for physical mounting instructions for the lamphouse.
3.
Electrical connection for the 35/70 Projector consists of the following connections and cables
•
Power cable from power supply to projector head (P/N EC00215-39)
•
Communications cable from control keypad to projector head (P/N EC00215-41)
•
AC Power cables for blower motor and power supply (P/N EC00215-35, 37)
•
Douser relay connection via P15.
•
RS-232 communication connections via P18 and J25.
•
BI-Phase input connections via P17.
•
BI-Phase output connections via J13.
•
SYNC input via J11.
1
Refer to interconnect diagrams in Section 8 for proper cable connections.
CHRISTIE INC. - 35/70 Service/PM Manual
July, 1997
2 . G e n e r a l D e s c r i p t i o n
1
:
Advertisement
Table of Contents
