Table of Contents
Advertisement
G 6 : T h e O U T P U T C U E T A P E S C o m m a n d [ D X ]
This diagnostic command downloads the position of each BOF and EOF cue tape, as it has been loaded into the projector,
to the show controller. The output data is in the format shown in Table 2.8.
E
NTRY
C
ODE
A
CTION
S
TATUS
G 7 : T h e S H U T T E R T E S T C o m m a n d [ D X ]
This diagnostic command is used to test the speed of the shutter. LED 0 on the control keypad is used as an indicator of
this test's success or failure.
E
NTRY
C
ODE
A
CTION
S
TATUS
CHRISTIE INC. - - 35/70 Service/PM Manual
CHRISTIE INC.
July, 1997
:
<CMD-G>, <6>
G6
:
1. Outputs PROMPT followed by BOF for first show.
:
S
2. Outputs successive BOF and EOF positions, each preceded by
a PROMPT.
Unchanged.
:
Output
<PROMPT>
hh:mm:ss:ff <PROMPT>
hh:mm:ss:ff <PROMPT>
hh:mm:ss:ff <PROMPT>
hh:mm:ss:ff <PROMPT>
. . .
Table 2.8: OUTPUT CUE TAPES Data Format.
<CMD-G>, <7>
:
:
G7 (also HD, from remote interface only)
LED 0 flashes and remains OFF if shutter speed is correct.
:
LED 0 flashes and remains ON if shutter speed is incorrect.
S
:
Unchanged.
3 : O p e r a t i n g t h e P r o j e c t o r
Meaning
<CR> <LF> *
BOF for Show #1
EOF for Show #1
BOF for Show #2
EOF for Show #2
repeated for
additional shows
Advertisement
Table of Contents
