Table of Contents
Advertisement
G 9 : T h e S H O W C O N T R O L E N A B L E C o m m a n d [ O P ]
This operational command toggles projector control between the right half of the control keypad and the RS232
communication port.
E
NTRY
C
ODE
A
CTION
S
TATUS
G A : T h e O U T P U T L O G C o m m a n d [ D X ]
This diagnostic command is used to report the last five commands sent to the projector over the RS-232 communication
port. The status is output on the RS-232 port to the show controller or the service terminal. These commands are
recorded only when the projector is in READY mode. The commands can be reported only when the projector is in the
NOT READY mode.
E
NTRY
C
ODE
A
CTIO
NS
S
TATUS
CHRISTIE INC. - - 35/70 Service/PM Manual
CHRISTIE INC.
July, 1997
:
<CMD-G>, <9>
G9
:
1. If the 9 LED is on, RS232 communication port control is
:
disabled and keypad control is enabled.
S
2. If the 9 LED is off, keypad control is disabled and RS232
communication port control is enabled.
Unchanged.
:
:
<CMD-G>, <A>
GA
:
The last five commands sent to the projector are output across
the RS-232 communication port, provided that the projector is
:
in NOT READY. The commands appear in the format
mm:ss:ff:<cmd>:<resp>, where
mm
= minutes
ss
= seconds
ff
= frame count within the second
<cmd> = command
<resp> = response
To illustrate this format:
0 3 : 5 7 : 1 4 : H 8 : 2
indicates that, at 3 minutes, 57 seconds, the 14th frame, the
command H8 was received, and the response 2 was made.
Unchanged.
:
3 : O p e r a t i n g t h e P r o j e c t o r
Advertisement
Table of Contents
