Table of Contents
Advertisement
G B : T h e T I M E C O D E I N Q U I R Y C o m m a n d [ D X ]
This diagnostic command is used to report the current timecode stored in the projector's internal buffer. The status is
output on the RS-232 port to the show controller or the service terminal.
E
NTRY
C
ODE
A
CTIO
NS
S
TATUS
G D : T h e P A R K O N C U E C o m m a n d [ O P ]
This command is used to park the BOF sensor tape in the gate. The use of this command is associated with operating the
projector in the Master or Slave mode and can be issued after a CUE command (See Section 2.8.9) has been issued. By
parking the BOF sensor tape in the gate proper frame synchronization between the Master and Slave projector is achieved.
E
NTRY
C
ODE
A
CTIO
NS
S
TATUS
G E : T h e E N G A G E S O U N D C o m m a n d [ O P ]
This command is used to engage the sound head lifter solenoid. This command is mainly used when projectors are
used in the Master/Slave configuration.
E
NTRY
C
ODE
A
CTIO
NS
S
TATUS
CHRISTIE INC. - - 35/70 Service/PM Manual
CHRISTIE INC.
July, 1997
:
<CMD-G>, <B>
GB
:
The current timecode is output across the RS-232
communication port in the counter format hh:mm:ss:ff (see
:
Section 0).
Unchanged.
:
<CMD-G>, <D>
:
:
GD
Cues film forward and parks BOF sensor tape in gate.
:
Set to A while parked at CUE point.
:
:
<CMD-G>, <E>
GE
:
Engages sound head lifter solenoid.
:
Unchanged.
:
3 : O p e r a t i n g t h e P r o j e c t o r
Advertisement
Table of Contents
