Table of Contents
Advertisement
8.
At the end of the show a CLOSE DOUSER (<C4>) command must be sent to the projector to close the douser and a
STOP (<K0>) command must be sent to the Master Motion Controller to stop the projector.
9.
From this point the projector must be taken out of interlock, with the LOCAL MODE (<HE>) command, and
rewound to the start of the show by entering a CUE NEXT (<H7>) command into the projector.
10. Repeat steps 2 to 9 to play the next show.
P o w e r D o w n S e q u e n c e
To turn off power to the projector, enter the following command key sequence:
(<G>,<9>) :
<STOP> :
<NOT RDY> :
Power to the projector, lamphouse, and show controller may then be removed in any order.
CHRISTIE INC. - - 35/70 Service/PM Manual
CHRISTIE INC.
July, 1997
Re-activate the projector keypad.
Stop the projector if it is in motion.
Remove power from projector motors.
3 : O p e r a t i n g t h e P r o j e c t o r
Advertisement
Table of Contents
