Table of Contents
Advertisement
G 3 : T h e A U T O D O U S E R C o m m a n d [ O P ]
This operational command enables the projector to automatically open the douser 3 seconds into the film after the
projector has been commanded to run FORWARD. This function is reset when the projector goes into a NOT READY
condition.
E
NTRY
C
ODE
A
CTION
S
TATUS
G 4 : T h e L O A D R E E L C O U N T E R C o m m a n d [ D X ]
This diagnostic command loads the time code value of the frame counter register into the reel counter register. This
command is used for motion programming, and is not a part of normal operation.
E
NTRY
C
ODE
A
CTION
S
TATUS
G 5 : T h e S E T P L A T T E R M O D E C o m m a n d s [ O P ]
This operational command sets the projector to platter mode. This command is recognized only in the NOT READY state.
E
NTRY
C
ODE
A
CTION
S
TATUS
CHRISTIE INC. - - 35/70 Service/PM Manual
CHRISTIE INC.
July, 1997
<G> , <3>
:
:
G3
Allows the douser to be automatically opened 3 seconds into the
:
film.
S
Unchanged.
:
:
<G> , <4>
G4
:
Sets the reel counter equal to the frame counter.
:
S
:
Unchanged.
:
<CMD-G>, <5>
G5
:
Disables upper and lower torque arm operation. Enter a NOT
:
READY command to reset projector to the default reel mode.
S
:
Unchanged.
3 : O p e r a t i n g t h e P r o j e c t o r
Advertisement
Table of Contents
