Table of Contents
Advertisement
Keypad LED
CLEAR
AUTO
FOR
STOP
REV
INTERLOCK
LOCAL
SET LOOP
READY
CUE
NOT RDY
CHRISTIE INC. - 35/70 Service/PM Manual
July, 1997
0
The CPU detected an error in the shutter speed.
1
The Lower Torque arm activated the limit switch.
2
The Upper Torque arm activated the limit switch.
3
The CPU detected that there is no film in the gate or there
was a pulldown malfunction.
4
The Lower Buckle arm is out of position.
5
The Upper Buckle arm is out of position.
6
The CPU detected a constant velocity fault.
7
There is BOF sensor tape in the gate.
8
There is EOF sensor tape in the gate.
9
Keypad control is enabled.
The projector is in the CYCLE TEST mode.
G
The projector is receiving or performing one of the G
function commands.
H
The projector is receiving or performing one of the H
function commands.
C
The projector is receiving or performing one of the C
function commands.
The projector is running forward.
The projector is stopped.
The projector is running in reverse.
The projector is in INTERLOCK mode.
The projector is in the LOCAL mode.
The projector is performing a loop set function.
The projector is in READY mode.
The projector is performing a CUE function.
The projector is in the NOT READY mode.
Table 2.3: Keypad LED Indicators
2 . G e n e r a l D e s c r i p t i o n
Indication
Advertisement
Table of Contents
