Table of Contents
Advertisement
E
NTRY
C
ODE
A
CTION
S
TATUS
H 8 : T h e S E T N E X T S H O W C o m m a n d [ O P ]
This operational command causes a display of the current show and the next show, respectively, in the two rightmost
digits of the numeric display. The user may enter a new next show number, if desired. The new value must be a valid
show number. If PLAY CURRENT SHOW (see Section 0) was the most recent play command, the projector also cues
to the next show. The current show and next show values are displayed for one second before the numeric display reverts
to the frame counter. The new next show value must be entered while the show values are displayed.
E
NTRY
C
ODE
A
CTION
I
NPUT
A
CTION
S
TATUS
H 9 : T h e S E T O P E R A T I N G F R E Q U E N C Y C o m m a n d [ D X ]
This diagnostic command selects the synchronization frequency, or line frequency, between 50 Hz and 60 Hz
default value is 60Hz operation. The battery backup RAM on the CPU card will maintain the frequency setting, so this
command should only be used once.
3
As shown in the two leftmost digits of the keypad LED display strip.
CHRISTIE INC. - - 35/70 Service/PM Manual
CHRISTIE INC.
July, 1997
:
<CMD-H>, <7>
H7
:
1. Move forward or backward at 120 fps until the BOF marker
:
for the next show is located.
S
2. Update frame counter.
3. Park at BOF mark.
:
Set to 8 while searching for BOF marker of next show.
Set to A while parked at cue point.
:
<CMD-H>, <8>
H8
:
1. Display current show in second-from-right position of
numeric display.
:
S
2. Display next show in rightmost position of numeric display.
:
Enter the number of the new next show, using the numeric
portion of the keypad. The entered value may not exceed
maximum shows (see Section 0).
1. Load the new next show value.
:
S
2. If PLAY CURRENT SHOW is the most recent play
command, cue to the next show.
:
As indicated by necessary motion.
3 : O p e r a t i n g t h e P r o j e c t o r
3
. The
Advertisement
Table of Contents
