Table of Contents
Advertisement
H 1 : T h e P L A Y C U R R E N T S H O W C o m m a n d [ O P , L ]
This operational command causes the system to play the current show. The command should be issued from a cue point.
Use this command instead of the FORWARD command to operate projectors configured for MASTER/SLAVE
operation.
E
NTRY
C
ODE
A
CTION
S
TATUS
H 2 : T h e S E T G O T O C o m m a n d [ D X ]
This diagnostic command allows the user to enter a goto point for a subsequent GOTO action. The goto point must be a
frame counter value in the current show. This command is used for motion programming, and is not a normal part of
system operations.
E
NTRY
C
ODE
I
NPUT
A
CTION
S
TATUS
CHRISTIE INC. - - 35/70 Service/PM Manual
CHRISTIE INC.
July, 1997
<CMD-H>, <1>
:
:
H1
1. Play current show.
:
S
2. Stop at tail of show.
3. Wait for SET NEXT SHOW command (see Section 0).
:
Set to 1 while moving to first frame.
Set to 3 while playing (douser open).
Set to 0 when stopped at end of show.
<CMD-H>, <2>
:
:
H2
1. Enter the desired goto point with the numeric portion of the
:
keypad. This is entered in the counter format hh:mm:ss:ff
(see Section 0).
2. Hit the <ENTER> key.
Load the goto point value.
:
S
:
Unchanged.
3 : O p e r a t i n g t h e P r o j e c t o r
Advertisement
Table of Contents
