Table of Contents
Advertisement
G 2 : T h e S E L E C T F R A M E R A T E S C o m m a n d s [ D X ]
This diagnostic command allows entry of the selected frame rate and the number of perfs per frame. Default values are 30
fps and 5 perforations unless specified otherwise. When using 35mm film select 5 perforations.
E
NTRY
C
ODE
I
NPUT
A
CTION
S
TATUS
CHRISTIE INC. - - 35/70 Service/PM Manual
CHRISTIE INC.
July, 1997
<CMD-G>, <2>
:
:
G2
:
1. Select the frame rate:
• Enter a 2 from the keypad to select 24 frames per second
• Enter a 5 from the keypad to select 25 frames per second
• Enter a 3 from the keypad to select 30 frames per second
• Enter a 4 from the keypad to select 48 frames per second
• Enter a 6 from the keypad to select 60 frames per second.
2. Select the number of film perfs:
• Enter a 5 from the keypad to select 5 perfs.
• For models equipped with 8-perf capabilities, enter an 8
from the keypad to select 8 perfs.
1. Reset frame rate and number of perfs.
:
S
2. Display frame rate in the second- and third-last positions on
the LED display, as shown in Figure 2.3.
3. Display number of perfs in the last position on the LED
display, as shown in Figure 2.3.
:
Unchanged.
HRS
Figure 2.3: SELECT FRAME RATES LED Display
3 : O p e r a t i n g t h e P r o j e c t o r
MIN
SEC
30 fps
FRS
5 perfs
Advertisement
Table of Contents
