Table of Contents
Advertisement
C F : T h e C Y C L E T E S T C o m m a n d [ D X ]
This diagnostic command initiates a CYCLE test for the projection system. When in the CYCLE mode, the projector
plays all programmed shows on the current reel of film in cine mode, then reverses to the beginning of Show #1 and
repeats the sequence. If the AUTO DOUSER command (See Section 2.8.37) has been entered prior to the CYCLE
TEST command, then the projector will automatically open the douser for each showing. The number of cycled shows is
equal to the value set with the SET MAXIMUM SHOWS command (see Section 0).
This sequence repeats until the projector is told to perform some other type of movement. The test ends when a second
CYCLE TEST command is entered. The current cycle completes, and the system returns to the start point of the first
show. A STOP command pauses the cycle; a FORWARD or REVERSE command resumes operation.
E
NTRY
C
ODE
A
CTION
S
TATUS
H 0 : T h e C U E / A D V A N C E C o m m a n d [ O P , L ]
This operational command is identical to the CUE sequence described in Section 0, except that film advances in the cine
mode.
E
NTRY
C
ODE
A
CTION
S
TATUS
CHRISTIE INC. - - 35/70 Service/PM Manual
CHRISTIE INC.
July, 1997
:
<AUTO>
CF
:
1. Play the show in cine mode.
:
S
2. Cue to the next show in sequence.
3. Park.
Repeats actions 1 - 3 until interrupted.
:
Set to A while parked at cue point;
set to 1 while moving to first frame;
set to 3 while playing;
set to 0 when stopped at end of show;
set to 8 while searching for BOF marker.
(The above status sequence repeats until the cycle ends.)
<CMD-H>, <0>
:
:
H0
1. Move forward at 15 fps in cine mode until BOF marker is
:
located.
S
2. Update frame counter.
3. Park at BOF mark.
:
Set to 8 while searching for BOF marker;
set to A while parked at cue point.
3 : O p e r a t i n g t h e P r o j e c t o r
Advertisement
Table of Contents
