Restoring The Settings Your Cubex 3D Printer Firmware From V1.01; How To Contact Cubify Support; Setting Up The Cubex Print Jet Offsets - 3D Systems CubeX Duo User Manual

15 . Plug the USB stick into the CubeX 3D Printer and press the control button; you will receive
a notification of your settings being restored. (Fig. 121)
16 . Your firmware has now been upgraded. (Fig. 122)
RESTORING THE SETTINGS YOUR CUBEX PRINTER FIRMWARE FROM V1.01
Before following these instructions, please follow instruction 1-9 in the section UPGRADING YOUR CUBEX PRINTER
FIRMWARE .
1 . Turn on the CubeX 3D Printer . You will see the activation screen .
2 . Re-activate your printer using your activation code . (if you do not have your activation code, you can locate it be going
to Cubify.com > MY ACCOUNT
3 . Once it is re-activated turn off the CubeX 3D Printer .
4 . Plug the USB stick into the CubeX 3D Printer and turn it on, touch the screen and you will receive a notification of your
settings being restored .
5 . Your firmware has now been upgraded.

HOW TO CONTACT CUBIFY SUPPORT

If you have any problems with your CubeX that cannot be solved using this manual, please contact
cubifysupport@cubify.com
SETTING THE CUBEX PRINT JET OFFSETS
CAUTION: Do not use the offset menu unless you have
!
been advised to do so by Cubify Support, as changes to
this may affect the quality of multi-material prints.
> MY DEVICES and then viewing your registered CubeX) .
for your support related issues .
34
Fig . 121
Fig . 122
Fig . 123