Table of Contents
Advertisement
Memory Module Installation
Carefully follow the steps below in order to install the DIMMs:
1.
To avoid generating static electricity and damaging the SO-DIMM, ground
yourself by touching a grounded metal surface or use a ground strap before you
touch the SO-DIMM.
2.
Do not touch the connectors of the SO-DIMM. Dirt or other residue may cause a
malfunction.
3.
Hold the SO-DIMM with its notch aligned with the memory socket of the board
and insert it at a 30-degree angle into the socket.
Figure 8 Align the SO-DIMM Memory Module with the onboard socket
4.
Fully insert the module into the socket until a "click" is heard.
5.
Press down on the SO-DIMM so that the tabs of the socket lock on both sides
of the module
Figure 9 Press down on the SO-DIMM Memory Module to lock it in place
Removing a DIMM:
To remove the SO-DIMM, use your fingers or a small screwdriver to carefully push
away the tabs that secure either side of the SO-DIMM. Lift it out of the socket.
Note: Make sure you store the SO-DIMM in an anti-static bag. The socket must be populated
with memory modules of the same size and manufacturer.
KEEX-4030 User's Manual
33
Chapter 3
Advertisement
Table of Contents
