This chapter describes the installation procedure for the Harmony 802.11b Access Point
and includes a description of the LEDs found on the unit.
Installation Procedure
Follow these steps to install the Harmony 802.11b Access Point Model 855x.
Note:
If you have a Harmony Access Point Controller, install it first before installing a
Harmony Access Point.
1.
Determine the best location for the Harmony 802.11b Access Point. Keep in mind
the following considerations:
G The length of the Ethernet cable that connects the Access Point to the network
must not exceed 100 meters.
G For Model 8550 Access Points, try to place the Access Point on a flat, sturdy
surface as far from the ground as possible, such as on top of a desk or book-
case, keeping clear of metal obstructions and away from direct sunlight.
G For Model 8551 Access Points, install the external antennas so that they are
clear of obstructions; refer to the documentation that came with the antennas for
mounting and installation instructions.
G Try to centrally locate the Access Point or its antennas so that it will provide
coverage to all of the mobile devices in the area.
G If you are not using the Harmony Power System to supply power to the Access
Point, the distance between the Access Point and a power outlet cannot exceed
the length of the power adapter's cable.
2. Installation
12