Qlogic SANbox 6142 User Manual page 95

Q
iSCSI Port Number: identifier for the iSCSI port (1 or 2).
■
Enable TCP Window Scaling: When you change this setting, you must enter
■
the Scale Factor (valid values are 0–5), then click Save (at the bottom of the
page) for the change to take effect.
TCP Max Window Size: the TCP maximum window size.
■
Target TCP Port Number: the TCP port number used by the
■
router to receive iSCSI target commands. The iSCSI community uses TCP port
number 3260 by default. If you change this setting, you must also make the
corresponding change in all iSCSI initiators connecting to this iSCSI target.
When you change the target TCP port number, you must click Save (at the bottom
of the page) for the change to take effect.
Jumbo Frame: the
■
maximum transfer units (MTUs). The Jumbo Frame setting is configured by a
menu containing ON or OFF selections. When this setting is OFF, 1500-byte
MTUs are supported. When this setting is ON, 9000-byte MTUs are supported.
When you change this setting, you must click Save (at the bottom of the page)
for the change to take effect.
Max Burst Length: the iSCSI maximum burst length.
■
FI0054601-00 A
Figure 7-22. Advanced Configuration Tabbed Page
SANbox 6142
7 – SANsurfer iSCSI/FC Router Manager
router supports both 1500-byte and 9000-byte
System Tree Window
SANbox 6142
7-25