Qlogic SANbox 6142 User Manual page 56

4 – Installation
Installing the SANbox 6142 Router
2. Configure the workstation serial port according to your platform. These steps
may vary according to the version of Windows you use:
For Windows:
❑
a. Open the HyperTerminal application. Click Start. Click Programs>
b. Enter a name for the router connection and choose an icon in the Connection
c. Enter the following COM Port settings in the COM Properties window and
❑
❑
❑
❑
❑
For Linux:
❑
a. Set up minicom to use the serial port. Create or modify the /etc/minirs.dfl file
b. Verify that all users have permission to run minicom. Review the
For Solaris: Modify the /etc/remote file to include the following lines.
❑
/dev/term/a refers to serial port a. Choose the "dv" setting to match the
workstation port to which you connected the router.
SANbox:
\:dv=/dev/term/a:br#115200:el=^C^S^Q^U^D:ie=%$:oe=^D:
3. Go to
4-6
Accessories>HyperTerminal>HyperTerminal.
Description window. Click OK.
click OK.
Bits per second: 115200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
with the following content:
pr portdev/ttyS0
pu minit
pu mreset
pu mhangup
pr portdev/ttyS0 specifies port 0 on the workstation. Choose the pr
setting to match the workstation port to which you connected the router.
/etc/minicom.users file and confirm that the line ALL exists or that there are
specific user entries.
section 4.2.8.
Q
FI0054601-00 A