Qlogic SANbox 6142 User Manual page 203

Q
Examples
The following is an example of the Remotemap add command:
QRouter (admin) #> remotemap add
The following wizard will create a mapping a device connected to the
local system and a device connected to the selected remote peer system.
If you wish to terminate this wizard before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index
-----
0
Please select a REMOTE system from the list above ('q' to quit) :
Index
-----
0
1
2
3
Please select a LOCAL device from the list above ('q' to quit)
Index
-----
0
1
Please select a REMOTE device from the list above ('q' to quit) :
NOTE: Both the LOCAL and REMOTE systems do not have the SMART-WRITE feature,
All attribute values for that have been changed will now be saved.
Examples
The following is an example of the Remotemap add command:
FI0054601-00 A
(System Info, Mgmt IP Address)
------------------------------
iSR-6142.0608A00487(172.17.137.215)
(WWNN,WWPN/iSCSI Name)
----------------------
20:20:00:d0:b2:02:86:d0,21:20:00:d0:b2:02:86:d0 (Init/Tgt)
20:21:00:d0:b2:02:86:d0,21:21:00:d0:b2:02:86:d0 (Init/Tgt)
20:20:00:d0:b2:02:86:d1,21:20:00:d0:b2:02:86:d1 (Init/Tgt)
20:21:00:d0:b2:02:86:d1,21:21:00:d0:b2:02:86:d1 (Init/Tgt)
(WWNN,WWPN/iSCSI Name)
----------------------
20:00:00:e0:8b:08:5f:3d,21:00:00:e0:8b:08:5f:3d (Initiator)
20:00:00:d0:b2:00:19:f0,21:00:00:d0:b2:00:19:f0 (Init/Tgt)
therefore the querying of the SMART-WRITE settings are not applicable
and will be skipped for this mapping.
A – Command Reference
Remote Map Command
0
: 0
0
A-31