Qlogic SANbox 6142 User Manual page 220
Intelligent storage router
Hide thumbs
Also See for SANbox 6142:
- User manual (310 pages) ,
- Supplementary manual (2 pages) ,
- Brochure (15 pages)
Table of Contents
Advertisement
A – Command Reference
Set Command
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both ports.
Configuring iSCSI Port: 2
---------------------------
Port Status (0=Enable, 1=Disable)
IP Address
Subnet Mask
Gateway IP Address
Target TCP Port No. (Min=1024, Max=65535)
Jumbo Frames (0=Enable, 1=Disable)
Window Size (0=8KB, 1=16KB, 2=32KB)
Window Scaling (0=Enable, 1=Disable)
Window Scaling Factor (Min=0, Max=5)
Link Rate (0=Auto, 1=10Mb, 2=100Mb, 3=1Gb)
Duplex (0=Auto, 1=Half, 2=Full)
Flow Control (0=Enable, 1=Disable)
Header Digests (0=Enable, 1=Disable)
Data Digests (0=Enable, 1=Disable)
Max Burst (Min=512B, Max=262144B)
Max First Burst (Min=512B, Max=32768B)
VLAN (0=Enable, 1=Disable)
VLAN Priority (Min=0, Max=7)
VLAN ID (Min=1, Max=4094)
All attribute values for Port 2 that have been changed will now be saved.
A-48
[Enabled
]
[10.3.5.107
]
[255.255.255.0
]
[0.0.0.0
]
[3260
]
[Disabled
]
[32768
]
[Disabled
] 0
[0
] 5
[Auto
] 3
[Auto
]
[Enabled
]
[Enabled
] 0
[Enabled
] 0
[262144
]
[32768
]
[Disabled
] 0
[0
]
[1
] 34
FI0054601-00 A
Q
Advertisement
Table of Contents
