Qlogic SANbox 6142 User Manual page 182
Intelligent storage router
Hide thumbs
Also See for SANbox 6142:
- User manual (310 pages) ,
- Supplementary manual (2 pages) ,
- Brochure (15 pages)
Table of Contents
Advertisement
A – Command Reference
FcipRoute Command
Examples
The following is an example of the FCIP route add command:
QRouter (admin) #> fciproute add
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE ports.
Configuring FCIP Route: 2
---------------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled
FC Port (1=FC1, 2=FC2)
GE Port (1=GE1, 2=GE2)
IP Address
Subnet Mask
Gateway IP Address
Remote IP Address
Jumbo Frames (0=Enabled, 1=Disabled)
TCP Window Size (0=8KB, 1=16KB, 2=32KB)
Window Scaling (0=Enable, 1=Disable)
TCP Port No. (Min=1024, Max=65535)
GE Link Rate (0=Auto, 1=10Mb, 2=100Mb, 3=1Gb) [Auto
FCIP Time Stamp (0=Enable, 1=Disable)
Error Detect TimeOut (Min=1sec, Max=5sec)
Resource Allocate TimeOut (Min=1sec, Max=5sec)[1
Bandwidth, Mbit/sec (Min=1, Max=1000)
VLAN (0=Enable, 1=Disable)
FCIP SW Compression (0=Enable, 1=Disable)
All attribute values for FCIP Route 1 will now be saved.
A-10
]
[FC2
]
[GE2
]
[0.0.0.0
] 10.2.2.10
[0.0.0.0
] 255.255.255.0
[0.0.0.0
]
[0.0.0.0
] 10.2.2.20
[Disabled
]
[32768
]
[Disabled
]
[3225
]
]
[Enabled
]
[1
]
]
[1000
]
[Disabled
]
[Disabled
]
FI0054601-00 A
Q
Advertisement
Table of Contents
