Qlogic SANbox 6142 User Manual page 109

Q
FCIP Interface Status: provides a dialog box for enabling and disabling the FCIP
■
route. When the route is disabled the FC and GE ports are placed in a down
state. All route configuration parameters are retained. If you change this setting,
you must click Save (at the bottom of the page) for the change to take effect.
FC Port: identifies the FC port used for this FCIP route. The FC port can not be
■
changed, it is selected when the route is created.
FC LInk Status: provides the state of the FC port used in this FCIP route.
■
GigE Port: identifies the gigabit Ethernet (GigE) port used for this FCIP route.
■
The GigE port can not be changed, it is selected when the route is created.
GigE Link Status: provides the state of the GigE port used in this FCIP route.
■
Local IP Address: the IP address to be used by the GigE port. An uninitialized
■
port has an IP address of all zeros. When you change this setting, you must click
Save (at the bottom of the page) for the change to take effect.
Remote IP Address: the IP address of the GigE port on the remote router. When
■
you change this setting, you must click Save (at the bottom of the page) for the
change to take effect.
Subnet Mask: the subnet mask used by the GigE port. When you change this
■
setting, you must click Save (at the bottom of the page) for the change to take
effect.
Gateway IP Address: the gateway IP address used by the GigE port. When you
■
change this setting, you must click Save (at the bottom of the page) for the change
to take effect.
Jumbo Frames: provides a dialog box for enabling and disabling Jumbo IP
■
frames. When disabled the MTU is 1500 bytes, when enabled the maximum
MTU is 9000 bytes. When you change this setting, you must click Save (at the
bottom of the page) for the change to take effect.
TCP Window Size: contains a dialog box that provides three options for TCP
■
window size; 8192, 16384 and 32768 bytes. The default is 32768. When you
change this setting, you must click Save (at the bottom of the page) for the change
to take effect.
Window Scaling: contains a dialog box for enabling and disabling TCP window
■
scaling. The default is disabled. If you change this setting, you must click Save
(at the bottom of the page) for the change to take effect.
Window Scaling Factor: contains a dialog box that provides six options for TCP
■
window scaling; 0–5. If you change this setting, you must click Save (at the
bottom of the page) for the change to take effect.
FI0054601-00 A
7 – SANsurfer iSCSI/FC Router Manager
System Tree Window
7-39