Qlogic SANbox 6142 User Manual page 193

Q
With FC Port Query
QRouter
The following wizard will query for attributes before persisting
and activating the updated mapping in the system configuration.
If you wish to terminate this wizard before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index
-----
0
1
Please select an Initiator from the list above ('q' to quit)
Index
-----
0
1
2
3
Please select a Target from the list above ('q' to quit)
iSCSI port used to access the Initiator (1=GE1, 2=GE2, ...)
FC port used to access the Target (1=FC1, 2=FC2, ...)
The selected initiator has not been presented on the port that
was selected to access the target.
wizard will now setup the initiator so that it is presented
on the port that will be used to access the target.
name for the presented initiator is assigned below.
the default assigned name simply press the ENTER key or enter a
new name.
FC presented initiator WWPN
The selected target has not been presented on the port that was
selected to be accessed the initiator.
wizard will now setup the target so that it is presented on the
port that will be used by the initiator.
presented target is assigned below.
name simply press the ENTER key or enter a new name.
iSCSI presented target name [iqn.2004-08.com.qlogic:isr-6142.0608a00471.1.220000
2037fd8bab.2000002037fd8bab] :
FI0054601-00 A
(admin) #> localmap add
(WWNN,WWPN/iSCSI Name)
----------------------
50:06:01:60:b0:22:0c:d1,50:06:01:68:30:22:0c:d1
iqn.1991-05.com.microsoft:qlogic-09sd5i4l
(WWNN,WWPN/iSCSI Name)
----------------------
20:00:00:20:37:fd:9c:f7,22:00:00:20:37:fd:9c:f7
50:06:01:60:b0:22:0c:d1,50:06:01:68:30:22:0c:d1
20:00:00:20:37:fd:8a:b0,22:00:00:20:37:fd:8a:b0
20:00:00:20:37:fd:8b:ab,22:00:00:20:37:fd:8b:ab
The following steps in the
[21:01:00:c0:dd:0c:8b:e2
The following steps in the
A default name for the
To accept the default assigned
A – Command Reference
Localmap Command
: 1
: 3
: 2
: 1
A default
To accept
] :
A-21