Qlogic SANbox 6142 User Manual page 183

Q
Examples
The following is an example of the FCIP route modify command:
QRouter (admin) #> fciproute mod
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE ports.
Route
-----
1
2
Please select a FCIP route from the list above ('q' to quit): 1
Configuring FCIP Route: 1
---------------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled
IP Address
Subnet Mask
Gateway IP Address
Remote IP Address
Jumbo Frames (0=Enabled, 1=Disabled)
TCP Window Size (0=8KB, 1=16KB, 2=32KB)
Window Scaling (0=Enable, 1=Disable)
TCP Port No. (Min=1024, Max=65535)
GE Link Rate (0=Auto, 1=10Mb, 2=100Mb, 3=1Gb) [Auto
FCIP Time Stamp (0=Enable, 1=Disable)
Error Detect TimeOut (Min=1sec, Max=5sec)
Resource Allocate TimeOut (Min=1sec, Max=5sec)[1
Bandwidth, Mbit/sec (Min=1, Max=1000)
VLAN (0=Enable, 1=Disable)
FCIP SW Compression (0=Enable, 1=Disable)
All attribute values for FCIP Route 1 will now be saved.
FI0054601-00 A
FC Port ID GE Port ID
---------- ----------
FC2 GE2
FC1 GE1
A – Command Reference
FcipRoute Command
]
[10.6.6.20 ]
[255.255.255.0 ]
[0.0.0.0 ] 10.6.6.1
[10.6.6.10 ]
[Disabled ]
[32768 ]
[Disabled ]
[3225 ]
]
[Enabled ]
[1 ]
]
[1000 ]
[Disabled ]
[Disabled ]
A-11