Qlogic SANbox 6142 User Manual page 111

Q
FCIP Timestamp: provides a dialog box for enabling and disabling FCIP
■
timestamps. The default is enabled. If you change this setting, you must click
Save (at the bottom of the page) for the change to take effect.
FCIP SW Compression: provides a dialog box for enabling and disabling FCIP
■
compression. The default is disabled. If you change this setting, you must click
Save (at the bottom of the page) for the change to take effect.
Bandwidth (Mbit/sec): provides a dialog box that allows the user to define the
■
maximum bandwidth (in megabits per second) used by the GigE port during
transmits. The range of values supported is1 to 1000 megabits per second. This
setting allows the user to limit the bandwidth used by the FCIP route so as to not
consume all the available link bandwidth. For example if the slowest link in the
WAN being used is a DS-3 link then the maximum available bandwidth is 45
megabits per second. To limit the FCIP route to 33% of the overall link bandwidth
set the bandwidth to 15 megabits per second. If you change this setting, you
must click Save (at the bottom of the page) for the change to take effect.
FI0054601-00 A
7 – SANsurfer iSCSI/FC Router Manager
System Tree Window
7-41