Ubee DDW365 User Manual page 76

Ubee Interactive
WPA/WPA2 Re-auth Interval
WEP Encryption
Shared Key Authentication
802.1x Authentication
Network Key 1-4
Current Network Key
Passphrase
Generate WEP Keys
Apply
Automatic Security Configuration — Sets up WPS (Wi-Fi Protected Setup) for devices connecting
to the wireless network.
WPS/Disabled
WPS Config State
Device Name
WPS Setup AP
UUID
PIN
Ubee DDW365 Advanced Wireless Gateway Subscriber User Guide • February 2014
Label
Sends a new group key to all clients at the specified interval
for a wireless router (if using WPA-PSK key management) or
RADIUS server (if using WPA key management). The re-
keying process is the WPA equivalent of automatically
changing the WEP key for a wireless access point and all
stations in the WLAN on a periodic basis. Setting the WPA
Group Key Update Timer is also supported in WPA-PSK
mode.
Enables or disables WEP encryption. If you do not have
wireless clients that can use WPA or WPA2, you can use WEP
key encrypting. A higher bit key offers better security. WEP
encryption scrambles the data transmitted between the wireless
stations and the DDW365 to keep network communications
private. It encrypts unicast and multicast communications in a
network. Both the wireless stations and the DDW365 must use
the same WEP key. Data Encryption can be set to WEP 128-
bit, 64-bit, or Disable.
Defines Shared Key Authentication as optional or required.
Shared Key is an authentication method used by wireless
LANs, which follow the IEEE 802.11 standard. Wireless
devices authenticate each other by using a secret key that is
kept by both devices.
Enables or disables 802.1x to authenticate wireless clients.
Pre-defines up to 4 keys for 64-bit or 128-bit (64-bit keys
require 10 hexadecimal digits) (128-bit key require 26
hexadecimal digits).
Selects one of the four pre-defined keys as the current
network key.
Sets the WEP encryption key by entering a word or group of
printable characters in the Passphrase box and clicking
Generate WEP keys. These characters are case sensitive.
Forces the device to generate 4 WEP keys automatically.
Saves changes.
Enables or disables WPS option. When enabled, the
following fields are available:
Defines if the WPS has been configured or not.
Defines a name for this wireless cable modem for WPS.
Defines the universal unique identifier (UUID) for this access
point.
Defines the Personal Identification Number for this access
point.
Using the Primary Network Option
Description
72