Download Print this page
Ubee DVW326B Safety And Installation

Ubee DVW326B Safety And Installation

Advanced wireless voice gateway

Advertisement

Quick Links

Ubee Interactive — www.ubeeinteractive.com
DVW326B Advanced Wireless Voice
Gateway - Safety and Installation
Product Insert
Federal Communications Commission
(FCC) Interference Statement
This device has been tested and found to comply
with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This device generates,
uses, and can radiate radio frequency energy. If
not installed and used in accordance with the
instructions, the device may cause harmful
interference to radio communications. There is
no guarantee, however, that interference will not
occur in a particular installation. If the DEVICE
causes harmful interference to radio or television
reception, which can be determined by turning it
off and on, the user can try to correct the
interference by one of the following measures:
1
Ubee DVW326B – Safety and Installation Product Insert
• Increase the separation between the DEVICE
and the equipment with which it is interfering
(for example, a television or radio).
• Connect the DEVICE into an electrical outlet
on a different circuit than the interfered device
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
FCC Regulatory Information
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
There is one statement for this product:
• Only the type of PIFA antenna tested may be
used.

Advertisement

loading

Summary of Contents for Ubee DVW326B

  • Page 1 • Only the type of PIFA antenna tested may be reception, which can be determined by turning it used. off and on, the user can try to correct the interference by one of the following measures: Ubee DVW326B – Safety and Installation Product Insert...
  • Page 2 This device must not be co-located or operating 6. Avoid static discharge when touching the in conjunction with any other antenna or device by first touching the coaxial connector transmitter. of the coaxial cable. Ubee DVW326B – Safety and Installation Product Insert...
  • Page 3: Installation

    RJ-45 connectors must be used when device will have the risk of tipping over. connecting Ethernet devices to the LAN ports. This ensures Gigabit Ethernet speeds (unless the computer does not support it). Ubee DVW326B – Safety and Installation Product Insert...
  • Page 4 4. Connect the power cord to the POWER port on the device. Plug the other end of the power cord into the AC wall outlet. Important: Use only the power cord that is shipped with the device. Ubee DVW326B – Safety and Installation Product Insert...
  • Page 5 B 1.9+/-0.15 2. Remove the device from the product package. C 19.0+/1.20 3. Mount the device on the wall. Refer to the The Screw’s Size (mm) following figure. Ubee DVW326B – Safety and Installation Product Insert...
  • Page 6: Additional Information

    When the device performs a service provider, some USB devices can be firmware upgrade, the DS/US connected here, such as computers, flash LED flashes. drives, etc. Ubee DVW326B – Safety and Installation Product Insert...
  • Page 7 4 minutes until a PIN is entered from a wireless client that wishes to connect. After a Wi-Fi client attaches successfully, the LED remains solid white for 5 minutes, and then turns off. Ubee DVW326B – Safety and Installation Product Insert...