Ubee DVW328 Safety And Installation
Ubee DVW328 Safety And Installation

Ubee DVW328 Safety And Installation

Advertisement

Ubee Interactive — www.ubeeinteractive.com
DVW328 Advanced Wireless Voice
Gateway - Safety and Installation
Product Insert
Federal Communications Commission
(FCC) Interference Statement
This device has been tested and found to comply
with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This device generates,
uses, and can radiate radio frequency energy. If
not installed and used in accordance with the
instructions, the device may cause harmful
interference to radio communications. There is
no guarantee, however, that interference will not
occur in a particular installation. If the DEVICE
causes harmful interference to radio or television
reception, which can be determined by turning it
off and on, the user can try to correct the
interference by one of the following measures:
1
Ubee DVW328 – Safety and Installation Product Insert v1.0
• Increase the separation between the DEVICE
and the equipment with which it is interfering
(for example, a television or radio).
• Connect the DEVICE into an electrical outlet
on a different circuit than the interfered device
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
FCC Regulatory Information
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
There is one statement for this product:
• Only the type of PIFA antenna tested may be
used.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DVW328 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ubee DVW328

  • Page 1 • Only the type of PIFA antenna tested may be interference by one of the following measures: used. Ubee DVW328 – Safety and Installation Product Insert v1.0...
  • Page 2 This device must not be co-located or operating 6. Avoid static discharge when touching the in conjunction with any other antenna or device by first touching the coaxial connector transmitter. of the coaxial cable. Ubee DVW328 – Safety and Installation Product Insert v1.0...
  • Page 3 RJ-45 connectors must be used when device will have the risk of tipping over. connecting Ethernet devices to the LAN ports. This ensures Gigabit Ethernet speeds (unless the computer does not support it). Ubee DVW328 – Safety and Installation Product Insert v1.0...
  • Page 4 4. Connect the power cord to the POWER port on the device. Plug the other end of the power cord into the AC wall outlet. Important: Use only the power cord that is shipped with the device. Ubee DVW328 – Safety and Installation Product Insert v1.0...
  • Page 5 B 1.9+/-0.15 and power connectors. C 19.0+/1.20 2. Remove the device from the product package. 3. Mount the device on the wall. 4. Refer to the following figure. The Screw’s Size (mm) Ubee DVW328 – Safety and Installation Product Insert v1.0...
  • Page 6 See the following diagram and descriptions of the address and configuration file, the LED flashes. device’s LED behavior, and the behavior of the When device obtains these items, the LED is On. back-panel Ethernet indicators. Ubee DVW328 – Safety and Installation Product Insert v1.0...
  • Page 7 4 minutes until a PIN is entered from a wireless client that wishes to connect. After a Wi-Fi client attaches successfully, the LED remains solid white for 5 minutes, and then turns off. Ubee DVW328 – Safety and Installation Product Insert v1.0...

This manual is also suitable for:

Dvw323bDxw3wb

Table of Contents