Understanding Specifications, Standards, And Firmware - Ubee DDW365 User Manual

Ubee Interactive
FRONT PANEL
LED Color
ONLINE White
WiFi White
WPS White
BUTTON
(top of
device)
REAR PANEL
Color
LED
ETH1 Green/
ETH2 Orange
ETH3
ETH4
1.6

Understanding Specifications, Standards, and Firmware

The following list provides the features and specifications of the DDW365.
Interfaces and Standards
 Cable: F-Connector, female
 LAN: 4 10/100/1000 Mbps RJ45 ports
 USB: 1 USB 2.0 host port
 DOCSIS 3.0 certified
 DOCSIS 1.0/1.1/2.0 certified
Ubee DDW365 Advanced Wireless Gateway Subscriber User Guide • February 2014
Description
Flashes – Obtaining an IP address and configuration file.
On – Configuration completed successfully.
On – WiFi is enabled.
Off – WiFi is disabled.
If not used, the LED is off. When a user pushes the WPS button or triggers WPS via the
device's Web UI, an LED on the top-front of the device blinks for 4 minutes until a PIN is
entered from the wireless client that wishes to connect (for example, a laptop computer). After
a WiFi client attaches successfully, the LED remains On for 5 minutes, then turns Off.
Description
– An Ethernet device is connected to the device at 1000 Mbps speeds (Gigabit
On Green
Ethernet).
– An Ethernet device is connected to the device at 10/100 Mbps speeds.
On Orange
or Orange) – When data is being passed between the cable modem and
Flashes (in Green
the connected device.
The Ethernet ports are used to connect Ethernet devices such as computers, gaming
consoles, and/or routers/hubs to the DDW365 using RJ-45 cables. Each Ethernet port on the
back panel of the device has an LED to indicate its status when an Ethernet device is
connected.

Understanding Specifications, Standards, and Firmware

7