Ubee DDW365 User Manual page 71

Ubee Interactive
Wireless Interfaces
Wireless
Country
Output Power
802.11 Band
802.11 n-mode
802.11 N Support Required
Bandwidth
Sideband for Control Channel
Ubee DDW365 Advanced Wireless Gateway Subscriber User Guide • February 2014
Label
Displays the unique SSID for the DDW365 or uses the
default. Refer to
page 8
Displays the wireless radio's status, Enabled or Disabled.
Defines the country where this device is used. The default
value is Q2.
Output power setup can be one of the following 4 options:
25%, 50%, 75%, or 100%.
Displays the 802.11 band (2.4GHz).
Sets the wireless networking standard. Select Auto to use
802.11 n mode when possible. This mode has a significant
increase in the maximum raw OSI physical layer data rate
from 54 Mbit/s to a maximum of 600 Mbit/s with the use of
four spatial streams when at a channel width of 40 MHz.
Defines whether 802.11n support is required (on) or not (off).
On forces the gateway to 802.11n mode and clients must
support 802.11n.
Sets the bandwidth to 20MHz or 40MHz. For 40 MHz, set the
sideband to lower or upper 20MHz. 40 MHz channels double
the channel width. This allows doubling the PHY data rate
over a single 20 MHz channel.
Only when using 40MHz Bandwidth should you choose the
Lower or Upper 20MHz.
Description
Understanding Default Values and Logins on
for more information on the SSID.
Using the Wireless Radio Option
67