Advertisement

Quick Links

DVW325 Advanced Wireless Voice
Gateway - Safety and Installation
Product Insert
Federal Communications Commission
(FCC) Interference Statement
This device has been tested and found to comply
with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This device generates,
uses, and can radiate radio frequency energy. If
not installed and used in accordance with the
instructions, the device may cause harmful
interference to radio communications. There is
no guarantee, however, that interference will not
occur in a particular installation. If the DEVICE
causes harmful interference to radio or television
reception, which can be determined by turning it
off and on, the user can try to correct the
interference by one of the following measures:
1
Ubee Interactive — www.ubeeinteractive.com
Ubee DVW325 – Safety and Installation Product Insert v1.0
Increase the separation between the
DEVICE and the equipment with which it is
interfering (for example, a television or
radio).
Connect the DEVICE into an electrical
outlet on a different circuit than the
interfered device is connected.
Consult the dealer or an experienced
radio/TV technician for help.

FCC Regulatory Information

This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
There are two statements for this product:
Only the type of Metal PIFA antenna tested
may be used.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DVW325 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ubee DVW325

  • Page 1  Only the type of Metal PIFA antenna tested interference by one of the following measures: may be used. Ubee DVW325 – Safety and Installation Product Insert v1.0...
  • Page 2 20cm Clean the device only with a clean, between itself and your body. dry cloth. Do not use liquid or Ubee DVW325 – Safety and Installation Product Insert v1.0...
  • Page 3 The device should be installed in a a cable line splitter (not included). location not to exceed the maximum temperature of 40 degrees Celsius Ubee DVW325 – Safety and Installation Product Insert v1.0...
  • Page 4 Connect the power adapter to the POWER port on the device. Plug the other end of the power adapter into the AC wall outlet. Important: Use only the power adapter Ubee DVW325 – Safety and Installation Product Insert v1.0...
  • Page 5 A 6.65+/-0.35 connectors. B 1.9+/-0.15 C 19.0+/1.20 Remove the device from the product package. The Screw’s Size (mm) Mount the device on the wall. Refer to the following figure. Ubee DVW325 – Safety and Installation Product Insert v1.0...
  • Page 6 LED flashes if power-on fails. Note that the LED USB connector is supported and enabled flashes briefly immediately after powering the by the service provider, some USB devices device. can be connected here, such as computers, Ubee DVW325 – Safety and Installation Product Insert v1.0...
  • Page 7 WPS (top of device)—If not used, the LED is Off. flashes. When the user pushes the WPS button or triggers WPS via the device’s web GUI, the LED flashes blue for 4 minutes until a PIN is entered Ubee DVW325 – Safety and Installation Product Insert v1.0...

Table of Contents